Skip to content
High Open Extrusion & Hotend

Filament blob encases hotend and breaks thermistor wires

A detached print can let molten filament wrap the nozzle, heater and wiring into a blob. The exposed thermistor and heater wires on the A1 hotend are easily damaged, by the blob or during removal. One owner could not reach any screws to remove the encased hotend; another found the hotend would not heat after removing a blob, and a replacement hotend did not fix it.

What fixes it

Good bed adhesion reduces the risk. Remove blobs slowly while the nozzle is hot and keep clear of the wires. Damaged wiring needs a replacement hotend heating assembly, and possibly further parts from support.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment