Skip to content
Low Open Firmware & Software

Asks to load and purge filament that is already loaded

Since the June 2026 firmware update, A1 and A1 Mini owners say the first print after the printer sits cold acts as if new filament was just loaded: it asks for confirmation, then pushes and purges filament before starting. It wastes filament and means walking to the printer to press continue. Owners say rolling back firmware stops it.

What fixes it

Roll back to the previous firmware. One owner fixed it by setting AMS type to "AMS 2 / H2D (Hermes)" with no AMS attached. One A1 owner says firmware 01.09.00.00 (Nov 9, 2026) fixed it; not yet confirmed by others.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment