Skip to content
Medium Open Extrusion & Hotend

Worn PTFE tubes cause under-extrusion and stringing

On MINIs with heavy use, the PTFE tubes wear inside, leading to under-extrusion, stringing, seams and weak or separated layers. Two owners fixed this by replacing a worn Bowden tube. One owner running three MINIs for about 7,000 hours each suggests replacing the hotend PTFE tube about every 1,000 hours and the other PTFE tubes about every 3,000 hours; as of mid 2025 Prusa's maintenance page did not list intervals.

What fixes it

Replace the Bowden tube (one owner used 1.9 mm ID) and the hotend PTFE tube when worn. One owner saw their pressure advance value drop from 0.28 to 0.1 after a new Bowden tube.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment