Original Prusa MINI+ known issues
What owners run into, most important first. Issues marked "from public reports" come from brand advisories, owner forums and reviews, linked on each one.
-
High Thermal runaway errors after firmware 8.0.0
After updating to firmware 8.0.0, MINI and MINI+ owners get thermal runaway errors that stop prints. One owner's logged temperatures looked normal, while another saw the nozzle running hot and fluctuating, and some saw it on 7.0.0 too. Prusa staff said on the forum that it is under investigation and advised rolling back.
What fixes it: Prusa staff recommend rolling back to firmware 6.4.2 until a fix ships; three owners confirm the rollback stopped the errors.
From public reports: forum.prusa3d.com, forum.prusa3d.com · Confirm or add a fix
-
Medium Worn PTFE tubes cause under-extrusion and stringing
On MINIs with heavy use, the PTFE tubes wear inside, leading to under-extrusion, stringing, seams and weak or separated layers. Two owners fixed this by replacing a worn Bowden tube. One owner running three MINIs for about 7,000 hours each suggests replacing the hotend PTFE tube about every 1,000 hours and the other PTFE tubes about every 3,000 hours; as of mid 2025 Prusa's maintenance page did not list intervals.
What fixes it: Replace the Bowden tube (one owner used 1.9 mm ID) and the hotend PTFE tube when worn. One owner saw their pressure advance value drop from 0.28 to 0.1 after a new Bowden tube.
From public reports: forum.prusa3d.com, forum.prusa3d.com · Confirm or add a fix
-
Low Wi-Fi through the ESP-01S module is flaky
The MINI+ relies on a small add-on ESP-01S module for Wi-Fi, and owners report failed module flashing, connections that only work some of the time, and trouble with mixed 2.4/5 GHz networks. Prusa's staff-run troubleshooting thread launched with a firmware release described as a beta for experienced users. A 2026 thread reports a generic module stuck scanning.
What fixes it: Connect the module to the 2.4 GHz band, avoid leading spaces and special characters in the network name and password, and force the module update at startup if flashing stalls.
From public reports: forum.prusa3d.com, forum.prusa3d.com · Confirm or add a fix