Bambu Lab H2C known issues
What owners run into, most important first. Issues marked "from public reports" come from brand advisories, owner forums and reviews, linked on each one.
-
Medium Extruder motor overload on the right nozzle
Some H2C owners hit repeated "extruder motor overload" errors with clicking and no filament feed, mostly on the right (Vortek) nozzle. Causes included clogs and possible nozzle or extruder misalignment, and H2D owners with the same error found debris and worn filament guides. Bambu replaced the whole extruder for one owner, which fixed it.
What fixes it: Clear debris from the extruder, check PTFE routing and clear nozzle clogs. If it persists, request an extruder replacement from support.
From public reports: forum.bambulab.com, forum.bambulab.com · Confirm or add a fix
-
Medium Gaps and under-extrusion on stock profiles
Early H2C owners found gaps between lines on top and bottom layers, between walls and infill, and on first layers with default Bambu and third-party PLA profiles. Raising flow about 3% or running manual flow calibration helped some. Bambu developers acknowledged the issue on GitHub and said a slicer mitigation would come first, with a full fix later.
What fixes it: Run manual flow calibration (an owner notes auto flow calibration only sets pressure advance), raise flow ratio a few percent, and increase infill/wall overlap. Results are mixed.
From public reports: forum.bambulab.com, github.com, forum.bambulab.com, forum.bambulab.com · Confirm or add a fix
-
Low TPU-for-AMS jobs blocked by firmware version check
Slicing a job with TPU fed through the AMS gives "your current firmware version cannot start this print job" even when the H2C is on the latest firmware, and the send button stays greyed out. A Bambu developer said it was fixed internally and would ship in the next release.
What fixes it: Wait for the next Bambu Studio or firmware release, which a Bambu developer says will contain the fix. The sources do not confirm it has shipped.
From public reports: github.com, forum.bambulab.com · Confirm or add a fix