Creality Ender-3 V3 Plus known issues
What owners run into, most important first. Issues marked "from public reports" come from brand advisories, owner forums and reviews, linked on each one.
-
High Printer locks up after a Creality Print 6 update
Many owners found the printer unresponsive after installing or using Creality Print 6: no temperature readings, homing or file list, and firmware updates that hang. Owners blamed a bad file or job sent from the new slicer. Most reports came in late December 2024 and early January 2025. One owner said a later Creality update fixed it, but another said many printers stayed bricked.
What fixes it: Owners recovered by logging into the printer's web interface (Fluidd on port 4408) and deleting recent jobs and files, or by a root SSH factory reset, then reflashing firmware. Creality support suggested a mainboard replacement to at least one owner.
From public reports: forum.creality.com, forum.creality.com · Confirm or add a fix
-
High Leveling sensor errors CL2529 / Key 2529 stop the printer
The printer shows CL2529 or Key 2529 (leveling sensor interference or chip fault), the nozzle stops short of the bed or never touches it, and printing cannot start. More than 30 owners reported it, many after updating to firmware 1.2.3.23 or a newer Creality Print release, others after days, months or over 1,000 hours of use.
What fixes it: Owners report fixes including lifting the bed and reseating the strain gauge connectors, adjusting the bed screws (too loose or too tight), rolling back to firmware 1.2.3.21 or Creality Print 5, and renaming G-code files to plain letters. Results are mixed and the error returned for some. Creality has sent replacement strain gauges, and in one case a mainboard, when contacted.
From public reports: forum.creality.com, forum.creality.com · Confirm or add a fix
-
Medium Extruder clicking and extrusion failures
The extruder clicks or grinds and filament stops feeding partway into a print even though the nozzle is not clogged. Causes found by owners vary: a gear rubbing on a metal part inside the extruder, a worn nozzle, or a hotend heater wire coming loose and giving wrong temperatures.
What fixes it: Check and clean the drive gears, check gear tension and recut the filament, then try a new nozzle. If clicking continues, inspect the hotend heater wiring; one owner fixed it only by moving to a K1C hotend after finding a loose heater wire. Results are mixed.
From public reports: forum.creality.com, forum.creality.com · Confirm or add a fix