Anycubic Kobra 3 V2 known issues
What owners run into, most important first. Issues marked "from public reports" come from brand advisories, owner forums and reviews, linked on each one.
-
Medium Large prints lift off the weak magnetic bed
The magnetic spring steel sheet does not hold large parts firmly; as big flat parts cool, the plate corners lift. A long-term tester also had prints flung off the plate and failed starts from adhesion errors.
What fixes it: Notebookcheck's reviewer clamped the plate corners, but warns clamps can damage the thin coating over the bed heater, so it is risky.
From public reports: notebookcheck.net, creativebloq.com · Confirm or add a fix
-
Medium Purge waste dragged or flung onto the print
During color changes the purge chute and wiper do not always clear the nozzle: the wiper sits too far away so the head drags residue onto the model, and the chute divider can stick and fling waste onto the bed. Seen in two reviews of the V2 Combo.
What fixes it: Notebookcheck's reviewer fixed the dragging by adding a rubber strip to the wiper so it reaches the nozzle.
From public reports: notebookcheck.net, creativebloq.com · Confirm or add a fix
-
Medium ACE Pro false tangle errors, misfeeds and clogs
The ACE Pro multicolor unit caused many failed prints in testing: false 'Tangled Filament' pauses, misfeeds during loading, the wrong color being fed, and clogs that left poorly fused layers. Each pause or error triggers extra purging that wastes filament. Reported by two reviewers in 2025.
What fixes it: No fix reported.
From public reports: creativebloq.com, tomshardware.com · Confirm or add a fix
-
Low AI spaghetti detection pauses good prints Fixed
At launch the camera's failure detection was far too sensitive, pausing prints that were fine. Anycubic later added a sensitivity adjustment in a firmware update.
What fixes it: Update the firmware and adjust the detection sensitivity, or turn detection off.
From public reports: tomshardware.com, creativebloq.com · Confirm or add a fix