Anycubic Kobra 3 known issues
What owners run into, most important first. Issues marked "from public reports" come from brand advisories, owner forums and reviews, linked on each one.
-
Medium Purge waste lands on prints; heavy filament waste
On the Kobra 3 V2 the purge slide does not always clear the nozzle, so filament residue gets dragged onto prints, and the waste flinger can get stuck and throw purge onto the bed. Multicolor prints can waste as much filament as the part itself (about 100 g on one PLA print).
What fixes it: One reviewer only fixed purge residue on prints by adding a rubber strip to the purge slide. Printing many multicolor parts on one plate lowers the relative waste, and the flung waste needs to be contained.
From public reports: notebookcheck.net, creativebloq.com, tomshardware.com · Confirm or add a fix
-
Medium ACE Pro false clog/tangle errors and feed failures
The ACE Pro reports clogs or tangled filament that are not there, misfeeds or loads the wrong color, and on some units stops feeding to the toolhead after a while. Owners have reported it since the Kobra 3 Combo launched in mid 2024, and it was still a main complaint in late 2025 reviews of the V2.
What fixes it: Check the PTFE tubes and the 4-way hub on the toolhead for blockages, clear jams in the ACE Pro feed path, and make sure the spool turns freely. Persistent cases go to Anycubic support for replacement parts.
From public reports: reddit.com, reddit.com, creativebloq.com, tomshardware.com · Confirm or add a fix
-
Low AI spaghetti detection too sensitive
The camera failure detection threw false alarms and paused good prints. A later firmware update added a sensitivity setting, which helps but has not ended it for everyone.
What fixes it: Update firmware and lower the detection sensitivity; some owners still turn it off.
From public reports: tomshardware.com, creativebloq.com · Confirm or add a fix
-
Medium First-layer and leveling failures on original Kobra 3
Anycubic said bed leveling and print success rates were among the biggest owner concerns with the original Kobra 3. The V2 changed the hardware (Y axis widened from 40 to 60 mm, new SG15 X bearing, LeviQ 3.0) to address it.
What fixes it: Anycubic has not described a retrofit for the original Kobra 3; the structural changes only exist in the V2 hardware.
From public reports: store.anycubic.com, reddit.com · Confirm or add a fix