Bambu Lab H3C known issues
What owners run into, most important first. Issues marked "from public reports" come from brand advisories, owner forums and reviews, linked on each one.
-
Medium Clicking noise from the rear motors after the first day
Within the first day or two of printing (about 8 to 38 hours), several H3C owners hear a clicking or ticking from the rear left motor area during prints and manual moves, and one also hears grinding on circular moves. Owners were on firmware 01.01.03.00. Bambu support asked for videos of diagonal moves to tell whether it comes from the motors or the idler pulleys; no cause has been confirmed yet.
What fixes it: No confirmed fix. Open a support ticket with a video of the noise. An H2C owner with a similar noise traced it to an idler next to the motors with belt residue on it.
From public reports: forum.bambulab.com · Confirm or add a fix
-
Medium H2C Build Plate Error on H3C
If you use any H2C's build plates you get a error that the H3C doesn't like that plate it says that it can bump into the toolchangers rack. You can disable this in the settings.
Reported by MaxdepoesGames · Confirm or add a fix