Skip to content

Newer version available: the Elegoo Neptune 4 Pro.

Low Open Firmware & Software

Filament runout sensor disabled on firmware 1.1.5.1b/1.1.5.1c

On the Neptune 3 Pro, the filament runout sensor stopped pausing prints after upgrading from 1.1.5.1a to 1.1.5.1b or 1.1.5.1c; the setting disappears from EEPROM. Another owner confirmed the same behavior and that only rolling back restored it.

What fixes it

Roll back to 1.1.5.1a with screen firmware 1.4.1, which restored the sensor for both owners. A community member suggested rebuilding firmware from source with the sensor re-enabled, but did not confirm it works.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment