Elegoo Neptune 3 Pro known issues
Newer version available: the Elegoo Neptune 4 Pro.
What owners run into, most important first. Issues marked "from public reports" come from brand advisories, owner forums and reviews, linked on each one.
-
Medium Nozzle heating failure and abnormal temperature errors
Neptune 3 Pro owners hit nozzle heating failures and overheat or underheat errors, including negative temperature readings and prints aborting midway. Elegoo has an official wiki page for these errors, and Printer Hub, citing it, names the toolhead ribbon cable as the most common cause, ahead of the thermistor and the mainboard.
What fixes it: With the printer on, slowly push the toolhead along X by hand; if the temperature jumps, replace the ribbon cable. Also inspect the adapter board pins and the thermistor lead, and follow Elegoo's wiki steps before replacing the board.
From public reports: wiki.elegoo.com, printer-hub.com · Confirm or add a fix
-
Medium Nozzle scrapes bed after firmware update (Z zero lost)
After updating to the 1.x.5.1b mainboard firmware, Neptune 3 series owners report the Z zero shifting so the nozzle scrapes a bed that was level before. About eight or nine owners across the Neptune 3, 3 Pro, 3 Plus and 3 Max joined the main GitHub thread in late 2023, and Elegoo support's answer to the original poster was that the mainboard was faulty. Printer Hub attributes it to a changed settings layout that misreads old EEPROM values. No official firmware fix was posted.
What fixes it: Reset settings to defaults after updating (M502 then M500), then redo bed leveling and Z offset. One owner fixed it by heating the bed before homing in the start G-code. The original poster said rolling back firmware did not help.
From public reports: github.com, printer-hub.com · Confirm or add a fix
-
Low Filament runout sensor disabled on firmware 1.1.5.1b/1.1.5.1c
On the Neptune 3 Pro, the filament runout sensor stopped pausing prints after upgrading from 1.1.5.1a to 1.1.5.1b or 1.1.5.1c; the setting disappears from EEPROM. Another owner confirmed the same behavior and that only rolling back restored it.
What fixes it: Roll back to 1.1.5.1a with screen firmware 1.4.1, which restored the sensor for both owners. A community member suggested rebuilding firmware from source with the sensor re-enabled, but did not confirm it works.
From public reports: github.com, printer-hub.com · Confirm or add a fix
-
Medium Random reboots that wipe Z offset and mesh
Several owners report the Neptune 3 Pro or Plus rebooting while using the menus quickly or starting a print, and a reboot can clear the stored Z offset and bed mesh. One thread ties it to the 1.x.5.1b firmware. Elegoo support told one owner the mainboard was at fault. A separate owner traced random shutdowns on his board to an overheating 3.3 V regulator.
What fixes it: One owner downgraded to 1.x.5.1a with screen firmware 1.4.1 and the reboots stopped. For heat-related shutdowns, one owner added a copper heatsink to the board's 3.3 V regulator. Elegoo support has offered to sell a replacement mainboard, though owners doubt it fixes the cause.
From public reports: github.com, github.com, github.com · Confirm or add a fix