Bambu Lab P2S known issues
What owners run into, most important first. Issues marked "from public reports" come from brand advisories, owner forums and reviews, linked on each one.
-
Medium Gaps in first layer from Z-offset and probing
Many P2S owners see gaps between first-layer lines and weak adhesion. Attention focused on the P2S start G-code using a positive Z-offset where other Bambu printers use negative ones, plus nozzle residue affecting the eddy-current probe. A Bambu developer said the issue is related to the printer and asked for logs; a later config update changed offsets for hot beds and added an extra nozzle wipe, with mixed results.
What fixes it: Update to firmware 01.02 or later and use the manual Z-offset or First Layer Quality calibration. Some owners set a negative Z-offset in start G-code or raise first-layer flow.
From public reports: github.com, github.com · Confirm or add a fix
-
Medium Extruder motor overload errors and clogs
Within weeks of launch, P2S owners reported frequent "extrusion motor overload" warnings, clogs and filament breaking in the extruder gears, including with PETG. One case traced to the quick-swap hotend clamp not being locked correctly; owners also pointed to PTFE tubes not seated straight, and some cases were unresolved. Owners also link clogs to the chamber running warm with the door closed.
What fixes it: Make sure the hotend clamp is fully locked (Bambu support confirmed this cause in one case), straighten and fully seat the PTFE tube, and clean the extruder. Support suggested printing with the door open for PETG.
From public reports: forum.bambulab.com, github.com · Confirm or add a fix
-
Low PETG forces chamber into heating mode, aux fan locked on
When printing PETG, the P2S switches its airflow to chamber heating mode and runs the aux fan around 50% regardless of fan settings. Owners report overhang sag, warmer chambers, warping and clogs. One Bambu developer said heating mode for PETG is by design; another suggested chamber temperature mode.
What fixes it: Community workarounds: set the PETG filament softening temperature below 50 °C so the printer picks cooling mode, or add cooling-mode commands to filament start G-code.
From public reports: github.com, github.com · Confirm or add a fix