QIDI Q1 Pro known issues
Newer version available: the QIDI Q2.
What owners run into, most important first. Issues marked "from public reports" come from brand advisories, owner forums and reviews, linked on each one.
-
Critical Chamber heater exposes mains voltage behind its grille
The chamber heater runs straight off wall power behind a safety grid, and Tom's Hardware warns you could get a shock by reaching in with a tool while it runs. The heater is not marked as hazardous. 3DPrintBeginner said it exposes live power, and 3DWork called the EU heater design potentially dangerous.
What fixes it: Never reach into the heater area while the printer is plugged in. A known-issues roundup says QIDI released a printable touch-proof cover for the heater.
From public reports: tomshardware.com, 3dprintbeginner.com, 3dwork.io, printer-hub.com · Confirm or add a fix
-
Medium Hotend heating errors and lost toolhead MCU connection
A known-issues roundup lists "Heater extruder not heating at expected rate" and "Lost communication with MCU MKS_THR" errors that stop prints, and traces them to a faulty hotend, the toolhead Type-C cable, or the toolhead adapter board. It also warns the ceramic heater can crack if the block is clamped wrong during nozzle changes.
What fixes it: The roundup suggests swapping in a spare hotend to isolate the fault, then replacing the hotend, Type-C cable or adapter board through QIDI support, and holding the heater block by its body when changing nozzles.
From public reports: printer-hub.com · Confirm or add a fix
-
Medium PLA and TPU heat creep jams in the closed chamber
With the lid and door closed, the warm chamber can soften low-temperature filament above the melt zone, causing jams. 3DWork warns about this for PLA and TPU, and a known-issues roundup also covers PETG.
What fixes it: For PLA, PETG and TPU, remove the top cover, crack the front door and run part and aux fans at 50% or more. Clear a clog with a cold pull.
From public reports: 3dwork.io, printer-hub.com · Confirm or add a fix
-
Low Ringing and ripples from flexible belt tensioners
The belt tensioners are held by only two screws and can move, and 3DPrintBeginner saw ringing and vibration artifacts on both axes. 3DPrint.com saw minor surface ripples and fixed them by adjusting belt tension and re-running input shaping.
What fixes it: Re-tension the X and Y belts and re-run input shaping, which fixed ripples for one reviewer.
From public reports: 3dprintbeginner.com, 3dprint.com · Confirm or add a fix
-
Low Old locked Klipper and missing stock profiles
The printer runs a customized, outdated Klipper build that cannot be easily updated, and one reviewer found the launch slicer profiles lacked generic PETG, ASA and TPU. Firmware 4.4.15 to 4.4.24 added or fixed power-loss resume, fixed a WLAN setting that could block booting, and fixed slow filament break detection, but did not move to mainline Klipper.
What fixes it: Update with QIDI's USB packages from its GitHub releases. One reviewer used similar profiles (PETG-CF for PETG, ABS for ASA) in place of the missing ones.
From public reports: 3dprintbeginner.com, 3dwork.io, github.com · Confirm or add a fix