Bambu Lab A1 known issues
What owners run into, most important first. Issues marked "from public reports" come from brand advisories, owner forums and reviews, linked on each one.
-
Critical Power board inrush thermistor can overheat and melt plastic Fixed
On the original AC power distribution board, the NTC inrush-current thermistor can fail and run very hot, softening nearby parts and in some reported cases melting the printer's plastic housing. Bambu says failures are rare (about 0.05%), tied mostly to power surges, and that the part was removed and the board redesigned in Q3 2025. No fires were reported, but it drew wide attention in late 2025.
What fixes it: Affected owners get a replacement power board from Bambu support, in or out of warranty. Bambu recommends a surge protector. Units built after Q3 2025 use the redesigned board.
From public reports: all3dp.com, tomshardware.com, forum.bambulab.com · Confirm or add a fix
-
Critical Heatbed cable recall over electrical and fire risk Fixed
In early 2024 Bambu found damage near the heatbed cable connector on some A1 units that could cause electrical failure, with at least one owner reporting the cable burning. Bambu first issued a callback in late January 2024, then extended it on Feb 4, 2024 to every A1 sold and asked owners to stop using them. Fewer than 0.1% of units had reported damage.
What fixes it: Bambu offered a full refund or a replacement heatbed with a revised cable (about a 20 minute swap), plus store credit and extra warranty. Later production units ship with the revised cable.
From public reports: blog.bambulab.com, forum.bambulab.com · Confirm or add a fix