Bambu Lab A1 known issues
What owners run into, most important first. Issues marked "from public reports" come from brand advisories, owner forums and reviews, linked on each one.
-
High Filament blob encases hotend and breaks thermistor wires
A detached print can let molten filament wrap the nozzle, heater and wiring into a blob. The exposed thermistor and heater wires on the A1 hotend are easily damaged, by the blob or during removal. One owner could not reach any screws to remove the encased hotend; another found the hotend would not heat after removing a blob, and a replacement hotend did not fix it.
What fixes it: Good bed adhesion reduces the risk. Remove blobs slowly while the nozzle is hot and keep clear of the wires. Damaged wiring needs a replacement hotend heating assembly, and possibly further parts from support.
From public reports: forum.bambulab.com, forum.bambulab.com · Confirm or add a fix
-
Low Asks to load and purge filament that is already loaded
Since the June 2026 firmware update, A1 and A1 Mini owners say the first print after the printer sits cold acts as if new filament was just loaded: it asks for confirmation, then pushes and purges filament before starting. It wastes filament and means walking to the printer to press continue. Owners say rolling back firmware stops it.
What fixes it: Roll back to the previous firmware. One owner fixed it by setting AMS type to "AMS 2 / H2D (Hermes)" with no AMS attached. One A1 owner says firmware 01.09.00.00 (Nov 9, 2026) fixed it; not yet confirmed by others.
From public reports: forum.bambulab.com, forum.bambulab.com · Confirm or add a fix
-
Low Firmware authorization blocks third-party printer control
Bambu's authorization control firmware requires approved software to start prints and control the printer. On updated A1 firmware, third-party tools that sent jobs or controlled the printer directly stop working unless the printer is put in LAN-only Developer Mode. Status reporting and SD card printing are unaffected.
What fixes it: Enable LAN Only mode plus Developer Mode, use Bambu Connect, or stay on older firmware.
From public reports: blog.bambulab.com, feedback.simplyprint.io · Confirm or add a fix