Bambu Lab P1S known issues
Newer version available: the Bambu Lab P2S.
What owners run into, most important first. Issues marked "from public reports" come from brand advisories, owner forums and reviews, linked on each one.
-
Low Firmware authorization blocks third-party printer control
Bambu's authorization control firmware requires approved software to start prints and control the printer. On updated P1 firmware, third-party tools that sent jobs or controlled the printer directly stop working unless the printer is put in LAN-only Developer Mode. Status reporting and SD card printing are unaffected.
What fixes it: Enable LAN Only mode plus Developer Mode, use Bambu Connect, or stay on older firmware.
From public reports: blog.bambulab.com, feedback.simplyprint.io · Confirm or add a fix
-
High Hotend will not heat or reports abnormal nozzle temperature
P1S owners report the hotend reading 0 or throwing nozzle temperature errors, often after clearing a clog or reseating the hotend. Fixes vary: one owner found a torn TH board FPC cable, while others replaced the hotend, TH board and cables without success. Two owners said rolling back to older firmware (one named 1.07, from 1.08) got them printing again.
What fixes it: Reseat hotend connectors and inspect the TH board FPC cable for tears. Some owners recovered by downgrading firmware; others needed toolhead parts from support. Results are mixed.
From public reports: forum.bambulab.com, forum.bambulab.com, forum.bambulab.com · Confirm or add a fix
-
High Heatbed temperature malfunction error (0300-8009)
Some P1S printers stop with a heatbed temperature malfunction error, or show the bed heating while the target reads 0. One owner said it got steadily worse until the printer was unusable. No single cause has been confirmed.
What fixes it: Check the bed power and signal cable connectors (Bambu's wiki covers cable, AC board and heatbed checks). A restart cleared it temporarily for one owner; otherwise open a ticket.
From public reports: forum.bambulab.com, wiki.bambulab.com · Confirm or add a fix
-
Medium PLA heat creep clogs with door and lid closed
With PLA on the textured plate (55 °C bed) and the enclosure shut, the chamber can get warm enough for filament to soften above the hotend and jam, especially in a warm room. Bambu's wiki names enclosure heat as the most common clog cause on the P1S and X1 Carbon.
What fixes it: Bambu recommends removing or opening the front door and top cover for PLA, PVA and TPU. Owners also leave the door cracked and a gap at the top glass on long prints.
From public reports: wiki.bambulab.com, forum.bambulab.com · Confirm or add a fix