Snapmaker U1 known issues
What owners run into, most important first. Issues marked "from public reports" come from brand advisories, owner forums and reviews, linked on each one.
-
Medium Toolhead pick-up and parking failures
Owners report toolheads failing to latch, release, or dock, mostly during first calibration, homing, or job start, with toolhead parking failure error codes. Snapmaker's troubleshooting page lists debris on the homing contact surfaces, an inner panel lifted when installing the filament holder, nozzle scraping and incorrect docking position as causes. Owners also suspect belt tension. Snapmaker added toolhead coordinate adjustment in firmware 0.9.4 and homing calibration in 1.0.0 to address these failures.
What fixes it: Update firmware, clean the homing contact areas, and check that no inner panel is lifted (Snapmaker). Owners also re-run belt tensioning slowly several times and adjust pick/park coordinates; results are mixed, and some owners still had failures afterward. Contact support if it persists.
From public reports: wiki.snapmaker.com, forum.snapmaker.com, forum.snapmaker.com, forum.snapmaker.com, releasebot.io · Confirm or add a fix
-
Low Touchscreen goes black and will not wake on firmware 2.1.0
On firmware 2.1.0, the U1 touchscreen can go black during a print and stop responding to touch. The print keeps running. Owners link it to the screen timeout, and Snapmaker staff asked for logs.
What fixes it: Set the screen timeout to Never. Snapmaker staff suggest long-pressing the top center of the screen for about 2 seconds; power cycling also brings it back.
From public reports: forum.snapmaker.com · Confirm or add a fix
-
Medium Nozzle drags or grinds across top surfaces and infill
Several owners in a long forum thread report the nozzle scraping through top layers and infill on flat parts, leaving rough surfaces. One owner says support told them it was normal behavior, and support also had them raise one motor's current, which only partly helped. One owner fixed it by reseating a loose lower toolchanger panel and another by rebuilding a belt tensioner with a stripped screw.
What fixes it: Snapmaker staff suggest flow calibration, 3 to 5 top layers, and slower top surfaces. Owners report fixes from reseating the lower toolchanger panel and repairing belt tensioners; results are mixed. Open a support ticket if it continues.
From public reports: forum.snapmaker.com, forum.snapmaker.com · Confirm or add a fix
-
Medium Prime tower collapse on multicolor prints
Tall multi-toolhead prints can lose the prime tower mid-print, which can ruin the job or knock debris around the chamber. Snapmaker has a dedicated U1 troubleshooting page for prime tower collapse.
What fixes it: Snapmaker has a troubleshooting page for U1 prime tower collapse; follow it and keep the plate clean so the tower base sticks.
From public reports: forum.snapmaker.com, all3dp.com, wiki.snapmaker.com · Confirm or add a fix
-
Low Pogo pin contact errors on toolheads
The U1 can throw a toolhead pogo pin contact anomaly when the swap contacts get dirty. Snapmaker shows a cleaning reminder every 100,000 swaps, but one owner hit the error twice in about 94 print hours.
What fixes it: Clean the pogo pins and contacts with isopropyl alcohol; this cleared it for the owner. Snapmaker support points to its troubleshooting guide and asks owners to contact support if it keeps happening.
From public reports: wiki.snapmaker.com, forum.snapmaker.com · Confirm or add a fix