Creality Ender-3 V3 known issues
Newer version available: the Creality Ender-3 V4.
What owners run into, most important first. Issues marked "from public reports" come from brand advisories, owner forums and reviews, linked on each one.
-
Low Loud noise on long X-axis moves
Several owners hear a loud rumble or grind during long X-axis travel while short moves are quiet. Prints are usually fine. One owner says Creality support told him the sound is normal and to lubricate the axis; other owners disagree that it is normal.
What fixes it: Owners suggest cleaning and greasing the lower X rod (one owner says the upper bushing is self-lubricating and should not be greased) and backing off overtight bearing set screws. Greasing did not stop the noise for the original poster, and no fix is confirmed. One owner says Creality may replace scored rods or bearings if shown a video.
From public reports: forum.creality.com · Confirm or add a fix
-
Medium Auto Z offset leaves first layer too close or too high
Owners report the automatic Z offset putting the nozzle nearly on the bed, or well above it unless auto calibration runs before every print. A Creality staff member said in April 2024 that the cause had been found and a software fix was coming. Reports continued after the May 2024 firmware.
What fixes it: Update firmware first (1.2.1.13 lists improved auto leveling and first layers, though reports continued after it). Owners otherwise adjust Z offset on the screen or store an offset in printer.cfg under prtouch_v2; note a self-level comments that line out again.
From public reports: forum.creality.com, forum.creality.com, forum.creality.com · Confirm or add a fix